Ultrasonic Essential Oil Diffusers FAQs

General Diffuser and Customer Tips

Essential oils can be corrosive so it’s important that the customer understands the importance of not letting the oils touch surfaces or the diffuser. They should wash their hands before they touch the unit, furniture, or adapter.

All of our units’ water tanks are made of oil-resistant PP (polymer polypropylene) plastic and are BPA free.

All NOW diffusers are in RoHS (Restriction of Hazardous Substances) compliance.

Frequently Asked Questions/Troubleshooting

Why is my diffuser not misting?

Water is incorrect temperature (too cold). Only lukewarm water should be used in ultrasonic units. If the water is too cold the unit will not work until the water warms.
Using distilled or purified water. Minerals play a key role in helping water turn into vapor. Our units are designed to work with just tap water as a result.
Unit needs to be cleaned as oil residue is clogging the ceramic disc. To clean, simply wipe down the unit with warm water and a soft cloth. A cotton swab dipped in alcohol (for deep cleaning only) can be used to break up the oil on the disc.

Why are the lights blinking on my diffuser?

Water may have come into contact with the circuit board, causing a malfunction. Unit will have to be replaced.
Ceramic disc needs to be cleaned. A cotton swab dipped in alcohol (for deep cleaning only) should be used to break up the oils. A cotton swab dipped in warm water will work for regular cleaning sessions.
The unit needs water. Add more water to the unit up to or slightly below the fill line. Unit will not run without water.

Is it ok for my diffuser to run continuously even though it is empty?

Each of our diffusers has a sensor which automatically turns the diffuser off when the unit is out of water. See instructions below on how to clean the sensor area if the unit remains on even though it has no water.
The water level indicator is dirty and the unit needs to be cleaned. The inside of the unit should be wiped down with warm water with a soft cloth. A cotton swab dipped in alcohol (for deep cleaning only) should be used to break up the oils. Pay close attention to this area to resolve this problem.

Should water collect on the vapor insert, lid nozzle or cover?

Condensation is a normal occurrence while the unit is misting. Remove cover and vapor insert and allow the unit to completely dry between uses.

Why is water splashing out of the top or puddling at the bottom of the unit?

Vapor insert is upside down or missing. Flip the vapor insert right side up or request a new one if missing. (Directional nozzle might be missing as well).
NOTE: Some units have the vapor insert directly attached to the cover. Repositioning and making sure it’s in place may resolve the above issue as well.